REPLACE AIR BOX HEATER IGNITION WIRE

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_471

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
410

TM 9-2350-277-20-2 REPLACE AIR BOX HEATER IGNITION WIRE 0204 00 THIS WORK PACKAGE COVERS: Removal (page 0204 00-1). Installation (page 0204 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Tie strap (2) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Power plant upper and lower rear access panels and support removed (see your -10) REMOVAL 1. Disconnect ignition wire (1) from air box igniter (2). 2. Remove two tie straps (3) from air pump wiring harness (4). Discard tie straps. 3. Disconnect other end of ignition wire (1) from ignition unit (5). 4. Loosen nut (6) and rotate solenoid receptacle (7) toward rear of carrier. Remove ignition wire (1). 0204 00-1

Privacy Statement
Press Release
Contact