REPLACE FUEL SUPPLY HOSES, TUBES AND FITTINGS (M577A3 AND M1068A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_379

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
326

TM 9-2350-277-20-2 REPLACE FUEL SUPPLY HOSES, TUBES AND FITTINGS (M577A3 AND M1068A3 ONLY) 0193 00 THIS WORK PACKAGE COVERS: Removal (page 0193 00-1). Installation (page 0193 00-5). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Sealing compound (WP 0928 00, Item 56) Wiping rag (WP 0928 00, Item 65) Grommet Locknut (4) Lockwasher (14) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (WP 0338 00) Fuel tanks drained (WP 0178 00) Power plant rear access panel removed (WP 0439 00) Rear compartment floor plates removed (WP 0539 00) or (WP 0544 00) REMOVAL WARNING Fuel flowing over a metal surface causes static electricity. This will cause a spark unless the surface is grounded. NOTE Use wiping rag to wipe up any spilled fuel. 1. Disconnect personnel heater fuel hose (1) from shutoff valve (2), if installed. 2. Remove shutoff valve (2) and nipple (3) from tube (4). 3. Remove four screws (5) and lockwashers (6) that secure four ground leads (7), clamps (8), and two elbows (9) to four weldnuts (10). Discard lockwashers. 0193 00-1

Privacy Statement
Press Release
Contact