BLOCK POWER PLANT

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_241

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
203

TM 9-2350-277-20-2 BLOCK POWER PLANT 0157 00 THIS WORK PACKAGE COVERS: Jacking (page 0157 00-1). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Power Plant Sling (WP 0926 00, Item 48) Materials/Parts Lumber, 4 x 6 x 40 inch (10 x 15 x 102 cm) Lumber, 4 x 6 x 20 inch (10 x 15 x 51 cm) (2) Personnel Required Unit Mechanic Helper (H) References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Power plant removed (WP 0156 00) PARKING BLOCK POWER PLANT WARNING Blocking power plant on unlevel, soft ground can cause power plant to sink and tip over. Personnel can be injured and power plant can be damaged. Make sure to block power plant on flat, hard ground. 1. Use a lifting device of at least 3,000 pounds (l,362 kg) capacity and sling to lift power plant. 2. On level ground, place a 4 x 6 x 40 inch (10 x 15 x 102 cm) block (1) under motor mounts of the engine (2). 3. On level ground, place two 4 x 6 x 20 inch (10 x 15 x 52 cm) blocks (3) and (4) under transmission (5). 4. Lower power plant down slowly onto blocks. Have helper assist. 0157 00-1

Privacy Statement
Press Release
Contact