TM 9-2350-277-20-1
STE/ICE TEST 80 BATTERY CURRENT
0132 00
THIS WORK PACKAGE COVERS:
Test (page 0132 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
Electrical connector pliers (WP 0926 00, Item 31)
Personnel Required
Unit Mech 63T10
References
See your -10
TM 9-4910-571-12&P
Equipment Condition
Engine stopped (see your -10)
Vehicle blocked (see your -10)
All electrical accessories turned off (see your -10)
STE/ICE hooked up to DCA 6 (WP 0117 00)
1.
Select TEST 80.
2.
Perform offset test.
a.
Press TEST button until CAL appears. Release TEST button.
b.
If VTM reads between -250 and +250, offset test passes.
c.
If offset test fails, go to STE/ICE DCA current shunt diagnostic troubleshooting (WP 0142 00).
3.
Press and release TEST button.
4.
Turn MASTER SWITCH to ON.
5.
Depress START button for five seconds.
a.
If VTM reads 0.0 or less (a larger negative number), test passes.
b.
If error message appears, see TM 9-4910-571-12&P.
c.
If engine cranks normally, but reading is erratic or cannot be obtained, go to STE/ICE DCA current shunt
diagnostic troubleshooting (WP 0142 00).
6.
Turn MASTER SWITCH to OFF.
7.
Return to troubleshooting.
0132 00-1/2 blank
