POWERPACK FUEL HOSES, TUBES AND CONNECTORS: REMOVAL AND INSTALLATION (CONTINUED)
AG Secure two tubes (24 and 29) to transmission using three screws
AL Connect free end of tube (4) to nipple (5).
(25), three new lockwashers (26), three flat washers (27), and six
loop clamps (28). Tube (29) must be to right of tube (24).
AM Secure tube (4) to angle bracket (15) using screw (11), new
lockwasher (12), nut (13) and loop clamp (14).
AH Secure two tubes (16 and 24) using two screws (20), two new
lockwashers (21), two nuts (22), and four straps (23). Tube (16)
AN Install elbow (3) on primary fuel filter (1) input.
must be above tube (24).
AO Install quick-disconnect coupling half (2) on elbow (3).
AI Secure tube (16) to engine using screw (17), new lockwasher
(18), and loop clamp (19).
AP Connect fuel line to quick-disconnect coupling half (2).
AJ Connect tube (4) to elbow (10).
AK Install elbow (9), adapter (8), check valve (6), two new preform-
ed packings (7), and nipple (5) on primary fuel filter (1) output.
TA57614 ~
4-21
Change 2
TM 9-2350-267-20
