HYDRAULIC RESERVOIR, FILTER AND FILLER CAP: REMOVAL AND INSTALLATION (CONTINUED)Remove two screws (16), two flat washers (17) and remove plate (18) fromRemove clamps (20) and pull hose (21) from fitting (22).K Remove fitting (22) from flange (23).L Disconnect electrical harness 12330252 connectors (24) from electricalconnector on housing assembly (25) and electrical connector to transmitter(26).M Remove hydraulic reservoir (4) by removing four screws (27) and fourNOTElockwashers (28) from hydraulic reservoir mounting plate (not shown).Discard lockwashers.Remove right projectile rack to gain access (p 11-5).N Remove tube (29), elbow (30) and reducer bushing (31) from filter (10).REMOVALO Remove filter (10) from bracket (32) by removing two screws (33), twolockwashers (34) and two flat washers (35). Discard lockwashers.A Close ball valve (1).P Remove two clamps (36) and pull hose (21) from fitting (37).B Disconnect hose assembly (2) from tee (3).Q Pull off cap (38) and remove six screws (39), six flat washers (40), sixC Place a suitable 15-gallon container under hose to catch hydraulic fluid fromlockwashers (41) and remove filler flange (42) and gasket (43) from platereservoir (4).(18). Discard lockwashers.D Open ball valve (1) and allow hydraulic fluid to drain into container.R Remove fitting (37) from plate (18).E Remove hose assembly (2), elbow (5) and reducer (6) from ball valve (1).INSTALLATIONFDisconnect hose assembly (7) from elbows (8 and 9). Remove elbow (9)A Apply tip sealant (item 57, AppxX D) to all male pipe threads.from filter (10).B Reverse removal pocedures using new lockwashers.G Remove elbow (8) and reducer bushing (11) from hydraulic reservoir (4)cover plate (12).NOTEH Remove ball valve (1), nipple (13), elbow (14) and bushing reducer (l5) fromRefer to LO 9-2350-267-12 for hydraulic fluid refillhydraulic reservoir (4).procedures.16-3Change 4TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
