MACHINE GUN SUPPORT ASSEMBLY: REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)CRemove quick-release pin (6), chain (7), and connecting link (8).D Install lock (12) on right-hand side of support (16). Positionspring (11) to engage slotted end of lock (12). Anchor tang ofD Remove and discard cotter pin (9).spring (11) on spring pin (15).E Remove cover (10), spring (11) and lock (12).ECheck travel of lock handle (12). Spring load should cause lock(12) to partially close pintle hole in support (16). One-fingerFRemove S-hook (13), chain (7) and quick-release pin (6) from con-pressure to rotate lock (12) should fully open pintle hole.netting link (8).FInstall cover (10) over spring (11) with new cotter pin (9).G Drive out spring pins (14) using punch and hammer. Discardspring pins.G Install connecting link (8) in support (16) with straight pin (5).Secure straight pin (5) and two new cotter pins (4).H Drive out spring pin (15) using punch and hammer. Discardspring pin.H Secure connecting link (8) with quick-release pin (6).ASSEMBLYINSTALLATIONA Install new spring pin (15) in support (16).Install support assembly (2) on commander’s cupola (3) with sixscrews (l).B Install two new spring pins (14).C Install S-hook (13), chain (7) and quick-release pin (6) on con-necting link (8).TA3129979-71/(9-72 blank)Change 1TM 9-2350-267-20All data on page 9-72 deleted
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
