AIR INTAKE GRILLE: REMOVAL AND INSTALLATION (CONTINUED)
INSTALLATION
A
B
c
D
E
F
Install two eyebolts (14) in grille (1). Attach sling (15) and a suitable lifting
device. Lift grille (1) into position and aline mounting holes.
Instal four hex key screws (21) in front of torsion bar tube clamps (20).
G
Insert bearing (25) in end of intake grille support (2). Secure bearing (25)
and support (2) with screw (22), flat washer (23) and new lockwasher (24).
H
Lower air intake grille (1).
I
Install four hex key screws (19) in rear of torsion bar tube clamps (20).
Install four hex key screws (17) in right end cap (18).
J
K
L
NOTE
Install torsion bar with grille at 90- to 95-degree open
position in no-loal condition.
Raise air intake grille (1) and insert torsion bar (9) from right side of
vehicle.
Position shield (27) and adapter (28) at left end of torsion bar (9) and secure
with three Screws (26).
Install shield and anchor (8) at right end of torsion bar (9) with two screws
(5), two flat washers (6) and two nuts (7).
Install exhaust deflector (4) with four screws (3).
Lower air intake grille (1) to closed position. Disconnect lifting device and
sling (15). Remove eyebolts (14).
Insert two studs (13) from bottom side of grille (1). Install two handles (12)
with two screws (10) and two new self-locking nuts (11).
9-66.3
Change 1
TA312974
TM 9-2360-267-20
