TM 9-2350-267-10OPERATING THE CONVEYOR - Continued12.13.Always engage mechanical safety lock beforebeginning conveyor operations. This will pre-vent uppar resr door from dropping if hydraulicsystem falls.Lower or raise upper rear door to either 45 or 90 degrees from closed position.This will engage mechanical safety lock. Raise door slightly until lock and lockstop are about 1/8 inch apart.Release rubber end-section latch (18) at each end of conveyor. Flip out eachend section (19) as shown below.NOTEEach conveyor end section (19) can be positionedat one of two angles (respective to angle of con-veyor), using adjusting plates (20) under each endsection.2-153
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
