TM 9-2350-261-20-4
REPLACE M13 NBC HEATER WIRING HARNESS (M577A2 ONLY) -- Continued
0670 00
8.
Install cable connector (1) on air purifier (2).
9.
Install forked end of ground lead (3) on cable connector (1) and tighten screw on cable connector.
NOTE
To ensure proper grounding, remove any paint from frame at ground point.
10. Install ground lead (3), screw (4), two washers (5), and new locknut (6) on panel (7).
11. Install new tie strap (8) on ground lead (3) and wiring harness (9).
12. In driver's compartment, install four clamps (10) on cable (11) and wiring harness (9).
13. Install four screws (12), new lockwashers (13), and four clamps (10) on weldnuts.
14. Connect wiring harness (9) to control box (14).
15. Install ground lead (15), two new lockwashers (16), and screw (17) on control box (14).
16. Install new tie straps (18) along cable (11) and adjacent wiring harness (9).
FOLLOW-THROUGH STEPS
1.
Connect battery ground lead (WP 0294 00).
END OF TASK
0670 00-4
