TM 9-2350-261-20-1
1.
2.
3.
4.
Set power control enclosure AC MAIN switch to OFF
(see TM 11-7010-256-12&P).
Remove cable W11 plug P2 (1) from light assembly plug
P1 (2).
Measure resistance between sockets of P2 (1) and pins
of plug P17 (3) on cable W11 (4) as follows:
P2 socket H to P17 pin A
P2 socket N to P17 pin B
P2 socket G to P17 pin C
Does multimeter read 0 ohms for each measurement?
1. Repair/replace light set assembly
(See TM 10-5410-229-13&P).
1. Replace cable W11 (page
40.1-75).
2. Verify no faults found.
3-226.68
Change 3
