R E M O V E / I N S T A L L 4 . 2 I N C H A M M U N I T I ON STOWAGE SPACER (M106A2)

R E M O V E / l N S T A L L M O R T A R M O U N T C O V E R I N I T I A L S E T U P Personnel Required: Equipment Driver Engine stopped (page-184) R E M O V E N O T E The mortar mount protects the off-vehicle mount in stowed position. cover mortar Pull up on catches and release hooks. Remove mortar mount cover. I N S T A L L Secure mortar mount cover on hooks and push down on catches. END OF TASK 5-8 ( M 1 2 5 A 2 )

INSTALL - TM-9-2350-261-10_511

TM-9-2350-261-10 Recovery Vehicle Full Tracked: Medium M88A1 NSN 2350-00-122-6826 Winch Power Takeoff and Hoist System Manual
Page Navigation
460

TM 9-2350-261-10 R E M O V E / I N S T A L L 4 . 2 I N C H A M M U N I T I ON STOWAGE SPACER (M106A2) INITIAL SETUP Personnel Required: Equipment Conditions: Soldier Engine stopped (page 2-184) Helper R E M O VE WARNING M329A2 mortar ammunition can explode if it is dropped or loose enough to move about when stowed in racks without proper spacers. Personnel can be killed or injured. Check that correct size spacers are in place before stowing mortar ammunition. NOTE Notify unit maintenance for initial installation of ammunition spacer kit if M329A2 ammunition is issued. If carrier is equipped with a personnel heater and ammunition spacer kit and if M329A1 ammunition is to be stowed, the spacers at rear and center racks can be removed by the crew (using tools in the tool bag) to stow 54 rounds of M329A1 ammunition. Use care to prevent dropping screws and washers inside hollow supports. If carrier is equipped with a personnel heater the spacers in the forward ammunition rack must be removed. Notify unit maintenance. 1. Remove screws and washers securing each spacer to supports. Retain all spacers, screws, and washers for future use. Use tools in tool bag, GO TO NEXT PAGE 5-9

Privacy Statement
Press Release
Contact