T U R N H E A T E R O FF

O P E R A T E E L E C T R O N I C E Q U I P M E N T H E A T E R ( M 5 7 7 A 2)

C H A P T E R 5 M106A2, M1064, AND M125A2 MORTAR CARRIERS

TM-9-2350-261-10 Recovery Vehicle Full Tracked: Medium M88A1 NSN 2350-00-122-6826 Winch Power Takeoff and Hoist System Manual
Page Navigation
451

TM 9-2350-261-10 2. From inside earner, press PRESS-TO-TEST switch. If light comes on, you have power. If light does not come on, troubleshoot heater (page 3-15). 3. Hold RUN-OFF-START switch to START until indicator light comes on. Then move switch to RUN, without stopping in OFF position. 4. Select high or low heat with . . . HI-LO switch. Heater will always start on low heat no matter where switch is set. It will go to high after it starts if switch is at HI. 5. If heater doesn’t start, try again. If it doesn’t start in three tries, troubleshoot heater (page 3-15). T U R N H E A T E R O FF 1. Move RUN-OFF-START switch to OFF. Heater will continue to operate for a few minutes until fuel is burned. Then, it will shut itself off. END OF TASK 4-40

Privacy Statement
Press Release
Contact