P R E P A R A T I O N B E F O R E W A T E R O P E R A T I O N S (cont)

P R E P A R A T I O N B E F O R E W A T E R O P E R A T I O N S

TM-9-2350-261-10 Recovery Vehicle Full Tracked: Medium M88A1 NSN 2350-00-122-6826 Winch Power Takeoff and Hoist System Manual
Page Navigation
337

TM 9-2350-261-10 N O TE Step 4 applies to the M106A2, M1064, and M125A2 0n1y. 4. 5. Install the air grille curtain (page 5-11). Check that all periscopes are in- stalled (page 2–191). WARNING Carrier could sink and personnel could drown with- out track shrouds secured in place. Carrier can have loss of steering without track shrouds. Do not attempt water operations without them. 6. Check that track shrouds and covers are in good condition and secured to carrier. TRACK COVER 7. Check front and rear bilge for debris or obstructions. pumps 8. Clean bilge pump screens of debris. N O TE To clean vent hole in front bilge pump, remove strainer. 9. Clean bilge pump vent holes of obstruction: a. b. c. d. e. Disconnect lead from front bilge pump. Remove two screws and tablock washers securing bilge pump strainer to weld nuts. Clean vent hole. Use a wire and run it back and forth in vent hole a few times. Install bilge pump strainer. Secure with two tablock washers and screws. Reconnect lead to front of bilge pump. 2-276 Change 3

Privacy Statement
Press Release
Contact