TM 9-2350-247-34
INSTALL VEHICLE COMPARTMENT HEATER KIT I (M548A1) — Continued
0055 00
37. Install control box bracket (1) on cowl below center windshield section and install four screws (2) and nuts (3).
38. Remove control box panel (see your -20).
39. Remove two existing control box mounting screws and nuts (supplied with control box). Discard screws and nuts.
40. Connect ground strap (4) on control box case (5). Use receptacle attaching screw and washer.
41. Install control box case (5) on bracket (1) and install two screws (6), lower resilient mounts (7) upper resilient
mounts (8), washers (9) and nuts (10). Tighten screws and nuts to compress resilient mounts to make 3/16 to 1/4 inch
(4.8 to 6.4 mm) space between bracket and control box case.
42. Install control box panel (see your -20).
0055 00-12
