TM 9-2350-247-20-3
REPLACE COMPRESSOR DRIVE PULLEY/BELTS (M548A1) — Continued
0499 00
INSTALLATION
1.
Insert woodruff key (1) in compressor shaft (2).
2.
Install compressor pulley (3) on compressor shaft (2) with washer (4), nut (5), and new cotter pin (6).
3.
Install compressor drive belts (7) on compressor pulley (3) and pulley (8).
4.
Adjust and align compressor drive belts (WP 0498 00).
FOLLOW-THROUGH STEPS
1.
Install compressor drive belt guard (WP 0497 00).
2.
Install power plant rear access cover/door (see your -10).
3.
Start engine (see your -10).
4.
Operate air brakes. Check compressor pulleys and belts for proper operation.
5.
Stop engine (see your -10).
6.
Install bulkhead protector, if material handling kit is installed (WP 0487 00).
END OF TASK
0499 00-3/4 blank
