TM 9-2350-247-20-2
REPLACE T150 TRACK ROAD WHEEL -- Continued
0361 01
2.
Loosen eight lock nuts (7) on road wheel (9). Do not remove nuts.
WARNING
Position retainer stops inside of end connector to prevent the lifter from slipping off and causing
injury or death to personnel.
3.
Install retainer (4), two flat washers (3), screws (2) , and T-nuts (1) on inside of track assembly.
4.
Place lifter (5) under road wheel arm (6). Keep lower tips of lifter in track link just rearward of wheel being removed.
5.
Unblock carrier (see your -10).
WARNING
If road wheel lifter slips while lowering road arm, it could injure you. Stand clear before you
lower road arm.
6.
Start engine (see your -10). Place gear selector in R. Slowly back carrier until lifter (5) is vertical and road wheel (9)
clears ground.
WARNING
Failure to set the parking brake and block the road wheels can allow the carrier to move and
could result in injury or death. Always set the parking brake and block road wheels before
working on the carrier.
7.
Block carrier (see your -10).
0361 01-2
Change 1