TM 9-2350-247-20-2
ADJUST TOW START CONTROL CABLE ASSEMBLY (M548A3) -- Continued
0311 00
2.
Push control cable assembly handle to full in position. Move control lever (4) to obtain 0.00 - 0.06 inch (0.00 - 0.15 cm)
clearance between contact surface of lever and transmission tow start button (5). Make sure cable housing end (6) to
lever (4) distance is a minimum of 2.50 inches (6.35 cm). Loosen clamp (7) and adjust as required.
3.
Position two collars (2) against clevis pin (8) and tighten two setscrews (1).
FOLLOW-THROUGH STEPS
1.
Install center floor plates (WP 0395 00).
2.
Lower center seat (see your -10).
END OF TASK
0311 00-2
