FRONT BILGE PUMP AND/OR LIGHT DOES NOT OPERATE

BILGE PUMP SYSTEM SCHEMATIC - TM-9-2350-247-20-1_407

FRONT BILGE PUMP AND/OR LIGHT DOES NOT OPERATEContinued - TM-9-2350-247-20-1_410

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
327

TM 9-2350-247-20-1 FRONT BILGE PUMP AND/OR LIGHT DOES NOT OPERATE 0084 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Multimeter (WP 0541 00, Item 29) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) MASTER SWITCH OFF (see your -10) Driver’s seat raised (see your -10) Center floor plates raised (WP 0394 00 or WP 0395 00) NOTE M548A1 and M548A3 troubleshooting procedures are the same. M548A1 procedure is shown. T 1. Turn MASTER SWITCH ON. 2. Turn BILGE PUMPS switch ON. 3. Does bilge pump light come on? YES NO GO TO BY (PAGE 0084 00-3) Y 1. Check bilge pump. 2. Does bilge pump fail to come on? YES NO GO TO CY (PAGE 0084 00-5) 0084 00-1

Privacy Statement
Press Release
Contact