TRANSMISSION DOES NOT HOLD 3RD POSITION (M548A3)Continued

TRANSMISSION DOES NOT HOLD 3RD POSITION (M548A3)

TRANSMISSION DOES NOT HOLD 3RD POSITION (M548A3)Continued - TM-9-2350-247-20-1_401

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
321

TM 9-2350-247-20-1 TRANSMISSION DOES NOT HOLD 3RD POSITION (M548A3)—Continued 0081 00 Y 1. Remove wiring harness 12313482 plug (1) from wiring harness 12313483 jack (2) at carrier bulkhead. 2. Measure voltage between each socket on wiring harness 12313483 jack (2) and ground. Multimeter should read 0 volts for sockets B (3), D (4), and H (5) and at least 18 volts for the remaining socket checks. 3. Does multimeter indicate an incorrect reading? YES NO YN 1. Replace wiring harness 12313482 (transmission shift control wiring harness, WP 0297 00). 2. Verify no faults found. 2Y 1. Turn MASTER SWITCH OFF. 2. Install wiring harness 12313482 plug on transmission jack. 3. Replace transmission shift control (WP 0306 00) 4. Place transmission shift control in 1–3 position. 5. Measure resistance between transmission shift control jack (1) pin M (2) and pins A thru G and N. Multimeter should read infinity for pins B and D, and 0 ohms for pins A, C, E, F, and G. See pin to pin check (WP 0309 00). 6. Does multimeter indicate an incorrect reading? YES NO 2YN 1. Install transmission shift control (WP 0306 00). 2. Replace wiring harness 12313483 (transmission wiring harness, WP 0297 00). 3. Verify no faults found. 0081 00-2

Privacy Statement
Press Release
Contact