TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITIONContinued

TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITIONContinued - TM-9-2350-247-20-1_356

TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITIONContinued - TM-9-2350-247-20-1_358

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
285

TM 9-2350-247-20-1 TURN SIGNAL LAMPS AND STOPLIGHTS DO NOT FLASH WITH CONTROL IN HAZARD POSITION—Continued 0066 00 12Y 1. Connect circuit 22-460 (right) and circuit 22-461 (left) connectors to circuit 22 connectors of right and left stoplight-taillights (WP 0507 00). 2. Remove blackout stoplight-taillight bulb (1). 3. Connect multimeter to bulb (1) and check for continuity. 4. Does multimeter indicate any continuity? YES NO 12YN 1. Replace blackout stoplight-taillight bulb (WP 0507 00). 2. Verify no faults found. 13Y 1. Disconnect circuit 23 connector (1) from blackout stoplight-taillight (2). 2. Turn MASTER SWITCH ON. 3. Connect multimeter between circuit 23 connector (1) and ground. 4. Does multimeter indicate voltage on circuit 23 connector? YES NO 13YN 1. Repair wiring harness (WP 0294 00). 2. Verify no faults found. 0066 00-7

Privacy Statement
Press Release
Contact