8-4. NO. 3 ROADWHEEL ARM TORSION BAR ANCHORS REPLACEMENT.
Install two torsion bar anchors (3) on floor of hull.
Install two washers (5) and screws (4) on each of two torsion bar anchors (3).
Torque two screws (4) to 245 ft-lb (332 Nm) and install new Iockwire (6) on screws (4).
Sealing compound can burn easily, can give off harmful vapors, and is harmful to skin
and clothing. To avoid injury or death, keep sealing compound away from open fire
and use in a weii-ventilated area. if sealing compound gets on skin or clothing, wash
immediately with soap and water.
Apply sealing compound around entire edge of cover plate (2).
Position cover plate (2) on floor of hull at crew compartment bulkhead and secure with eight screws (1)
Install lower fuel tank (para 4-4).
Install torsion bars (refer to TM 9-2350-287-20-2).