| |
TM 9-2350-287-20-2
13-2. TOWING PINTLE REPAIR (continued).
a.
REMOVAL
1.
Remove two eyebolts (1) from
rear of vehicle.
2.
Remove four screws (5) and
lockwashers (4) and bracket
(3)
from
rear
of
vehicle.
Discard lockwashers.
3.
Remove cotter pin (2) from
slotted nut (8). Discard cotter
pin.
4.
Remove
slotted
nut
(8),
bearing (7), and towing pintle
body (6) from bracket (3).
b.
DISASSEMBLY
WARNING
Use care when removing retaining rings. Retaining rings are under spring tension
and can act as projectiles when released and could cause severe eye injury.
1.
Remove two retaining rings (12) from pin (13). Discard retaining rings.
WARNING
Jaw will drop out of pintle body when pin is removed. Support jaw when removing
pin or injury to personnel could occur.
2.
Remove pin (13) and jaw (15) from pintle body (6).
3.
Remove fitting (14) from pin (13).
WARNING
Use care when removing retaining rings. Retaining rings are under spring tension
and can act as projectiles when released and could cause severe eye injury.
4.
Remove two retaining rings (11) from pin (10). Discard retaining rings.
NOTE
Spring will drop out of pintle body when latch is removed.
13-2
|