| |
TM 9-2350-287-20-2
20.1-5. GPS MOUNTING BRACKET ASSEMBLY REPAIR (continued).
c.
ASSEMBLY
1.
Install identification plate (20) on mounting plate (14).
2.
Install GPS mount (15) on mounting plate (14) with four screws (19) and washers (18).
3.
Install block and gasket (10) on mounting plate (14) with four screws (21) and washers (22).
4.
Install spare fuse (16) and fuse holder (17) on mounting plate (14).
5.
Install four isolators (25) on adapter mount (9) with eight screws (1), new lockwashers (2), and nuts (3).
6.
Install mounting plate (14) on adapter mount (9) with four screws (23) and washers (24).
d.
INSTALLATION
1.
Install adapter mount (9) on
canister compartment support
(7) with three screws (8),
washers (6), new lockwashers
(5), and nuts (4).
2.
Route
power
and
antenna
cables through two loop clamps
(13).
3.
Install two loop clamps (13) on
mounting plate (14) with two
screws (11) and washers (12).
FOLLOW-ON MAINTENANCE:
Install GPS receiver in mounting bracket (refer to TM 11-5825-291-13).
Change 1 20.1-8
|