|
| |
TM 9-2350-287-20-2
17-28. HYDRAULIC CONTROL PANEL ASSEMBLY REPAIR.
This Task Covers:
a. Removal
b. Disassembly
c. Cleaning and Inspection
d. Assembly
e. Installation
Initial Setup:
Tools/Test Equipment:
Lockwasher (Item 166, Appendix H)
Automotive electrical tool kit (Item 5,
Lockwasher (19) (Item 196, Appendix H)
Appendix I)
Preformed packing (3) (Item 226, Appendix H)
Drain pan (Item 14, Appendix I)
Preformed packing (4) (Item 232, Appendix H)
General mechanic's tool kit (Item 24,
Appendix I)
Equipment Conditions:
Vehicle parked on level ground (refer to
Materials/Parts:
TM 9-2350-287-10).
Cap and plug set (Item 13, Appendix D)
Hydraulic system pressure relieved to 0 psi
Dry-cleaning solvent (Item 27, Appendix D)
(refer to TM 9-2350-287-10).
Rag (Item 56, Appendix D) (as required)
Mounted water ration heater (MWRH) power
Teflon pipe sealant (Item 63, Appendix D)
cable (12447321) removed (refer to TM 9-2350-
Lockwasher (Item 164, Appendix H)
287-10).
a.
REMOVAL
WARNING
To avoid possible injury, make sure
all systems are shut down and
MASTER switch is set to OFF.
Hydraulic fluid may be hot and can
cause burns.
CAUTION
To
prevent
contamination
of
hydraulic system, hydraulic lines
and
ports
should
be
capped
immediately
after
disconnecting
lines.
NOTE
Tag
all
electrical
leads
and
hydraulic tubes and hoses for
identification at installation.
1.
Remove screw (4), two lockwashers (3), and
ground wire (2) from hydraulic control panel
assembly (1). Discard lockwashers.
Change 1 17-81
|
