| |
TM 9-2350-287-20-2
17-16. ROD ENDS AND LATCH REPLACEMENT (continued).
b.
1.
2.
3.
4.
5.
6.
7.
INSTALLATION
Install bracket (15) on takeup-end section assembly (1) with two screws (20), new Iockwashers (19), and
washers (18).
Install rubber latch (14) on bracket (15) with pin (21) and clip (16).
Install two nuts (12) on two rod ends (11). Tighten nuts (12) to end of threads on two rod ends (11).
Install two rod ends (11 ) on two takeup plates (2) with two screws (7), new Iockwashers (9), washers (8), and
nuts (10).
Install two flanged bearings (3) on takeup-end section assembly (1) with four screws (6), new Iockwashers
(5), and washers (4).
Back up nut (12) on each rod end (11) until each nut (12) touches bracket (17) on each side of takeup-end
section assembly (1).
Install nut (13) on each of two rod ends (11).
FOLLOW-ON MAINTENANCE:
l Stow conveyor (refer to TM 9-2350-287-10).
17-41
|