|
| |
TM 9-2350-287-20-2
17-9. DRIVE-END SECTION ASSEMBLY REPAIR (continued).
5.
Install two side wear strips (16) on drive-end section (1) with 20 screws (15).
6.
7.
Install bracket (9) on drive-end section (1) with two screws (13), new Iockwashers (12), and washers (11).
Install rubber latch (8) on bracket (9) with pin (14) and clip (10).
8.
9.
Position conveyor drive-end section
(1) on conveyor center section (2).
Install three screws (3), new
Iockwashers (6), washers (5), and nuts
(7) on two hinge assemblies (4).
FOLLOW-ON MAINTENANCE:
l Install dead-end section on drive-end section (para 17-8).
l Install conveyor assembly (para 17-6).
l Install conveyor toggle clamp and tube assembly (para 17-18).
l Install drive-end section coupling sprocket, pillow blocks, and
drive sprocket assembly (para 17-14).
17-23
|
