| |
TM 9-2350-287-20-2
15-85. PROJECTILE RACK REMOVAL AID REPAIR (continued).
c.
ASSEMBLY
WARNING
Adhesives can burn easily, can give off harmful vapors, and are harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash immediately with soap
and water.
1.
If nylon wear strips (12) were removed, apply rubber adhesive to rough side of new wear strip (12) and mating
surface on plate (11 or 14). Allow to dry until tacky. Install wear strips (12) on plate (11 or 14).
2.
Install four cam followers (22) on two plates (11 and 14) with eight washers (18), four new lockwashers (17), and
four nuts (16).
3.
Install shaft (21) between two plates (11 and 14) with two washers (20) and new cotter pins (19).
4.
Connect plate (14), spacer (13), and plate (11) with screw (15), two washers (10), new lockwasher (9), and nut
(8).
5.
Slide trolley assembly (2) onto beam (1).
6.
Install extension (4) on beam (1) with four screws (3), washers (5), new lockwashers (6), and nuts (7).
FOLLOW-ON MAINTENANCE:
Stow projectile rack removal aid in vehicle (refer to TM 9-2350-287-10).
15-213
|