|
| |
TM 9-2350-287-20-2
15-79. DRIVER’S STOWAGE BOX REPAIR.
This Task Covers:
a. Disassembly
b. Assembly
Initial Setup:
Tool/Test Equipment:
l Rivet (2) (Item 252, Appendix H)
l Blind hand riveter (Item 10, Appendix 1)
l General mechanic's tool kit (Item 24,
Equipment Conditions:
Appendix 1)
• Vehicle parked on level ground (refer to
• Electric drill (Item 43, Appendix 1)
TM 9-2350-287-10).
• Twist drill, 3/16-inch (Item 73, Appendix I)
Materials/Parts:
l Rivet (4) (Item 251, Appendix H)
a.
DISASSEMBLY
1.
2.
3.
4.
5.
6.
7.
b.
1.
2.
3.
Chip guarding and personal protective equipment (goggles/shieid, gloves, etc.), must
be worn when driving out rivets. Failure to follow this warning may result in injury to
personnel.
Drill out two rivets (7) from hinge (6) and remove hinge (6), with door (5) attached, from driver’s stowage box
(3).
Drill out two rivets (2) from turnlock receptacle (4), and remove turnlock receptacle (4) from stowage box (3).
Discard rivets.
Drill out two rivets (8) from hinge (6), and remove hinge (6) from door (5). Discard rivets.
Drive cross pin (1) from stud assembly (9).
Remove stud assembly (9) from turnlock eyelet (10).
Install cross pin (1) in stud assembly (9).
Drive turnlock eyelet (10) from door (5).
ASSEMBLY
Install turnlock eyelet (10) in door (5).
Drive cross pin (1) from stud assembly (9).
Install stud assembly (9) through turnlock eyelet (10).
15-192
|
