|
| |
TM 9-2350-287-20-2
15-47. COMMANDER’S ACCESS DOOR REPAIR.
This Task Covers:
a. Removal
b. Disassembly
c. Cleaning and Inspection
d. Assembly
e. Installation
f. Adjustment
Initial Setup:
Tools/Test Equipment:
• Lockwasher (2) (Item 126, Appendix H)
• General mechanic’s tool kit
• Lockwasher (2) (Item 163, Appendix H)
(Item 24, Appendix I)
• Spring pin (Item 351, Appendix H)
Materials/Parts:
Personnel Required: Two
• Adhesive, rubber (Item 5, Appendix D)
• Drycleaning solvent (Item 28,
Equipment Conditions:
Appendix D)
• Vehicle parked on level ground (refer to
• Grease (Item 32, Appendix D)
TM 9-2350-287-10).
• Rag (Item 56, Appendix D)
a.
REMOVAL
1.
Unlatch access door (1) and hold in upright position to release tension on flat springs (3).
2.
Remove two screws (4) and Iockwashers (5) from access door (1). Discard Iockwashers.
NOTE
Prior to removal, record location, quantity, and position of spacer plates, spacers, flat
springs, and washers.
3.
Remove guy anchor (6), spacer plate(s) (7), and spacer(s) (8) from access door (1).
4.
Remove 12 flat springs (3), tube (2), and washer(s) (9) from access door (1).
15-117
|
