|
| |
TM 9-2350-287-20-2
15-46. COMMANDER'S CUPOLA BODY REPAIR (continued).
c.
INSTALLATION
WARNING
Adhesives can burn easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash immediately with soap and
water.
1.
Apply thin coat of adhesive to seal channel in door frame and to mating surfaces of new hatch door seal (48).
Allow adhesive to dry for five minutes or until tacky.
NOTE
Hatch door seal is difficult to reposition once it is placed in seal channel. Avoid
stretching or bunching hatch door seal.
2.
Aline hatch door seal (48) with seal channel in door frame. Press hatch door seal (48) firmly in seal channel.
Allow adhesive to cure for 30 minutes.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
3.
Clean excess adhesive from door frame with drycleaning solvent and rags.
4.
Install guide (47), spring (46), retainer (45), and pin (44) on latch handle (23).
5.
Screw pin (41) into latch handle (23).
6.
Install release lever (43) and pin (42) in latch handle (23).
15-114
|
