|
| |
TM 9-2350-287-20-2
15-43. AFES FIRE EXTINGUISHER BOX ASSEMBLY REPAIR.
This Task Covers:
a. Removal
b. Disassembly
c. Cleaning and Inspection
d. Assembly
e. Installation
Initial Setup:
Tool/Test Equipment:
• Endless sling (Item 20, Appendix 1)
• Five-ton hoist (Item 23, Appendix 1)
• General mechanic’s tool kit (Item 24,
Appendix 1)
Materials/Parts:
• Adhesive, rubber (Item 5, Appendix D)
• Adhesive, sealant (Item 6, Appendix D)
• Drycleaning solvent (Item 28, Appendix D)
• Rag (Item 56, Appendix D)
• Cotter pin (Item 37, Appendix H)
• Lockwasher(13) (Item 166, Appendix H)
• Self-locking nut (4) (Item 330, Appendix H)
Personnel Required: Two
Equipment Conditions:
• Vehicle parked on level ground (refer to
TM 9-2350-287-10).
• Crew AFES cylinder bottles removed
(para 21-5).
a.
REMOVAL
1.
Attach sling to two lifting eyes (1).
2.
Attach sling to hoist and take up slack.
WARNING
AFES fire extinguisher box
assembly is heavy. To
prevent injury, make sure
box assembly is supported
3
when screws are removed.
Remove 13 screws (2) and Iockwashers
(3) from AFES fire extinguisher box as-
sembly (4) and rear wall of vehicle hull.
Discard Iockwashers.
4.
With the help of assistant, lower lifting
device and place AFES fire extinguisher
box assembly (4) on clean work surface.
5.
Remove sling and hoist from two lifting
eyes (1).
15-104
|
