|
| |
15-30. CANISTER AND PERSONNEL SIDE DOORWAY SEALS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic's tool kit (item 24,
Appendix I)
Materials/Parts:
• Adhesive, rubber (Item 5, Appendix D)
• Drycleaning solvent (Item 28, Appendix D)
• Rag (Item 56, Appendix D)
• Seal (left door) (Item 274, Appendix H)
• Seal (right door) (Item 274, Appendix H)
• Seal (personnel door) (Item 277, Appendix H)
• Shim (right door) (Item 338, Appendix H)
• Shim (left door) (Item 339, Appendix H)
• Shim (personnel door) (Item 341, Appendix H)
Equipment Conditions:
• Canister or personnel side door opened
and secured (refer to TM 9-2350-287-10).
a.
REMOVAL
NOTE
Seals in two canister doorways and personnel side doorway are replaced the same way.
1.
Pry up and remove old seal (2) and rubber shim (1) from channel (3) in door frame. Discard seal and shim.
WARNING
2.
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
Using drycleaning solvent and rags, clean all adhesive and shim residue from channel (3) in door frame.
15-69
TM 9-2350-287-20-2
|
