|
| |
TM 9-2350-287-20-2
15-19. TOP DOOR INNER SEALS REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
TooIs/Test Equipment:
• Shim (Item 340, Appendix H)
• General mechanic’s tool kit (Item 24,
Appendix I)
Equipment Conditions:
• Vehicle parked on level ground (refer to
Materials/Parts:
(TM 9-2350-287-10).
• Adhesive, rubber (Item 5, Appendix D)
• Top left, right, and middle doors opened
• Drycleaning solvent (Item 28, Appendix D)
(refer to TM 9-2350-287-10).
• Rag (Item 56, Appendix D)
• Seal (Item 275, Appendix H)
a.
REMOVAL
1.
Remove top door inner seal (1) and shim (2) from channel (3). Discard shim and seal.
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT use near open flame or excessive heat.
2.
Clean adhesive residue from channel (3) with drycleaning solvent and rags.
b.
INSTALLATION
WARNING
Adhesives can bum easily, can give off harmful vapors, and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive gets on skin or clothing, wash Immediately with soap and
water.
1.
Apply adhesive to mounting surfaces of channel (3), new shim (2) and new seal (1). Allow adhesive to dry
until tacky.
NOTE
For best results, do not stretch or bunch shim or seal during installation.
2.
Install inner seal (1) and shim (2) on channel (3).
15-40
|
