TM 9-2350-287-20-l
7-49. ENGINE BRACKET TO DRIVERS BULKHEAD WIRING HARNESS (12353403)
REPLACEMENT
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/lest Equipment
l General mechanics tool kit (Item 24,
Appendix 1)
Materials/Parts:
Gasket (Item 50, Appendix H)
Lockwasher (Item 129, Appendix H)
Lockwasher (4) (Item 173, Appendix H)
l Lockwasher (2) (Item 175, Appendix H)
Personnel Required: Two
Equipment Conditions:
l Vehicle parked on level ground (refer to
TM 9-2350-287-10).
l MASTER switch set to OFF (refer to
TM 9-2350-287-1 0).
l Battery access doors opened (refer to
(TM 9-2350-287-10).
l Left and right transmission access doors
opened (refer to TM 9-2350-287-10).
Battery ground cables disconnected (para 7-41).
a.
REMOVAL
1.
While an assistant holds screw inside drivers compartment, remove four nuts (l), lockwashers (2), and
washers (3), electrical connector (4), and gasket (5) from drivers compartment bulkhead. Discard
Iockwashers and gasket, and reinstall nuts and washers.
7-143