TM 9-2350-287-20-1
7-34. RIGHT TAlLLAMP ASSEMBLY REPAIR (continued).
b.
1.
2.
3.
4.
c.
1.
2.
3.
d.
1.
2.
3.
4.
DISASSEMBLY
Loosen six screws (11) with six retaining rings (12) on taillamp assembly (1).
Remove door (13) and gasket (14) from taillamp assembly (1). Discard gasket.
Open front cover of LED (15) and push in LED (15) with screwdriver, turn counterclockwise and remove from
taillamp assembly (1).
Push in LED (16) with screwdriver, turn counterclockwke, and remove from taillamp assembly (1).
ASSEMBLY
Install LED (16) on taillamp assembly (1) by pushing in with screwdriver and turning LED (16) clockwise until
seated.
Install LED (15) on taillamp assembly (1) by pushing in with screwdriver and turning LED (15) clockwise. Close
front cover of LED (15).
Install door (13) and new gasket (14) on taillamp assembly (1) with six screws (11) and retaining rings (12).
INSTALLATION
Install grommet (10) and two electrical leads (6) on hull.
Install taillamp assembly (1) on hull with two screws (4), new Iockwashers (3), and washers (2).
Connect two electrical leads (6) to wiring harness (5).
Install four spacers (7), cover plate (9), and four screws (8) on hull.
7-98