TM 9-2350-287-20-1
7-32. HEADLIGHT SEALED-BEAM AND INCANDESCENT LAMP REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
l General mechanics tool kit (Item 24,
Appendix l)
Materials/Parts:
l Gasket (2) (Item 100, Appendix H)
l Lockwasher (4) (Item 126, Appendix H)
Equipment Conditions:
l Vehicle parked on level ground (refer to
TM 9-2350-287-10).
l MASTER switch set to OFF (refer to
TM 9-2350-287-10).
a.
1.
2.
3.
4.
5.
6.
REMOVAL
Remove four screws (6) and Iockwashers (7) and cover (8) from headlight body (1). Discard Iockwashers.
Pull two sealed-beam lamps (5) out of headlight body (1).
Disconnect two electrical connectors (2) from two sealed-beam lamps (5).
Open front cover of marker assembly (9) and push in marker assembly (9) with screwdriver, turn
counterclockwise, and remove from headlight body (1).
Pull out and remove blackout drive reflector (3) with incandescent lamp (4) from headlight body (1).
Push in incandescent lamp (4), turn counterclockwise, and remove from blackout drive socket (3).
7-92