TM 9-2350-287-20-1
7-4. RECTIFIER REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
General mechanics tool kit (Item 24,
Vehicle parked on level ground (refer to
Appendix I)
TM 9-2350-287-10).
Left and right transmission access doors opened
Materials/Parts:
(refer to TM 9-2350-287-10).
Silicone compound (Item 64, Appendix D)
Battery ground cables disconnected (para 7-41).
LockWasher (2) (Item 142, Appendix H)
a.
1.
2.
3.
4.
5.
b.
1.
2.
3.
4.
5.
REMOVAL
Disconnect two wiring harness connectors (7 and 8) at rectifier (1 ).
Remove six screws (5) and washers (4) from rectifier (1).
Remove two brass screws (3) and Iockwashers (2) from rectifier (1). Discard Iockwashers.
Remove rectifier (1) from bulkhead.
Remove packing (6) from base of rectifier (1). Scrape base clean.
INSTALLATION
Remove paint from base of rectifier (1) and mating surface of hull, if required. Make certain all surfaces are
clean.
Coat base of rectifier (1) and mating surface of hull with silicone compound.
Install packing (6) in base of rectifier (1).
Install rectifier (1) on bulkhead using two new Iockwashers (2) and brass screws (3) and six washers (4) and
screws (5).
Connnect two wiring harness connectors (7 and 8) at rectifier (1 ).
7-12