TM 9-2350-287-20-1
7-1 .
GENERAL.
This chapter illustrates and describes the removal and installation of powerpack and hull electrical systems and
components. Procedures are also included for the disassembly, assembly, and checks and adjustments of
components, as authorized by the maintenance allocation chart (MAC) for Unit maintenance.
Disassemble components only to the extent required to correct a malfunction or defect. Replace only those parts
necessary to correct the malfunction, and install the mandatory replacement parts at that point.
7-2. GENERATOR (ALTERNATOR) REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools/Test Equipment:
Equipment Conditions:
l General mechanics tool kit (Item 24,
Vehicle parked on level ground (refer to
Appendix I)
TM 9-2350-287-10).
. MASTER switch OFF (refer to TM 9-2350-287-10).
Materials/Parts:
Battery ground cables disconnected (para 7-41).
l LockWasher (6) (Item 163, Appendix H)
Radiator removed from vehicle (para 6-6).
l LockWasher (7) (Item 164, Appendix H)
Personnel Required: Two
a.
1.
2.
REMOVAL
Remove seven screws (1) and Iockwashers (2) and plate (4) from shroud assembly (5). Discard lockwashers.
Disconnect alternator-to-rectifier wiring harness (3) at alternator (6).
7-3