TM 9-2350-287-20-1
4-28. ACCELERATOR, THROTTLE, AND ENGINE CONTROL GOVERNOR REPLACEMENT
AND ADJUSTMENT (continued).
NOTE
Rod end bearing of throttle rod assembly cannot be removed from hand lever
assembly.
8.
Remove cotter pin (33) and pin (25) from throttle rod assembly (32) and lever (26). Discard cotter pin.
9.
Remove screw (31 ), key washer (30), hand Iever assembly (27), and throttle rod assembly (32) from bulkhead
(24).
10.
Remove throttle rod assembly (32) from hand lever assembly (27) by loosening nut (29) and rotating throttle
rod assembly (32) off of threads of rod end (28).
11.
12.
13.
14.
Remove spring (39) from accelerator pedal
assembly (38) and bulkhead (24).
Remove two screws (34), Iockwashers (35),
and washers (36) and accelerator bracket
(37) from mounting bracket (40). Discard
Iockwashers.
Lift accelerator pedal assembly (38) until
accelerator bracket (37) clears mounting
bracket (40).
Remove accelerator pedal assembly (38),
accelerator bracket (37), and lever (26) from
mounting bracket (40) and bulkhead (24) as
an assembly.
4-87