2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/lCE) (continued).
b. STE/lCE TROUBLESHOOTING - (continued).
(8) CHARGING CIRCUIT (at battery) - TEST 67.
Tools/Test Equipment:
General mechanics tool kit (Item 24, Appendix I)
STE/lCE test set (Item 65, Appendix I)
A. 1. Connect DCA cable W1 connector P1 to VTM
connector J1.
2. Connect DCA cable W1 to harness 12329996
connector at DCA receptacle in driver's compart-
ment.
3. Push power switch on VTM to ON position.
4. Do confidence test 66/99 (para 2-22.a(1)).
5. Dial 60 into TEST SELECT.
6. Press and release TEST button. Message
VEH should be displayed on the VTM.
7. Enter the vehicle ID number 11.
8. Enter 67intoTEST SELECT, then press TEST
button to check static voltage.
Is static voltage at least 22 volts?
test 73 (para 2-22.b(3), and test 89 (para 2-
22. b(20).
B. 1. Enter 02 into TEST SELECT and press TEST
button.
2. When VTM shows CON, enter 67 into TEST
SELECT and press TEST button.
3. Crank engine (refer to TM 9-2350-287-10)
while holding fuel shutoff handle out.
4. Record results of cranking test.
Is cranking test voltage at least 18 volts?
Do individual battery test 75 (para 2-22.b(4)
and test 73 (para 2-22.b(3). If necessary,
do test 89 (para 2-22.b(20).
Continued to step C
2-417
TM 9-2350-287-20-1
Do individual battery test 75 (para 2-22.b(4),