TM 9-2350-287-20-1
If only part of display shows, module
may beburned out. Go to TM 9-
4910-571-12&P for replacement.
2-22. SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION
ENGINES (STE/lCE) (continued).
Continued from step A
B. Make sure VTM display lights up.
Does VTM display light up?
D. 1. Pull VTM power switch to OFF position.
2. Disconnect DCA cable W1 from harness W100
DCA receptacle and from STE/lCE VTM con-
nector J1.
3. Connect DCA cable W5 to VTM connector Jl.
4. Connect DCA cable W5 to known good bat-
tery.
5. Push VTM power switch to ON position.
I
Does VTM display show .8.8.8.8 and then change
to - - -?
I
Go to TM 9-4910-571-12&P to
fault isolate cable W5.
Continued to next page
2-382