TM 9-2350-287-10
OPERATING THE CONVEYOR (continued)
15. If conveyor (2) must be raised higher than long legs of two slings (6) allow:
a. Make sure the two conveyor support struts (8) are locked in position.
b. Position upper rear door (9) at 45 degrees from closed position (p. 2-138).
c. Lower upper rear door (9) until tension on two slings (6) is relieved.
d. Remove quick-release pin (16) from left sling (6) and disconnect long leg of sling (6)
from left side of conveyor (2).
e. Connect short leg of left sling (6) to left side of conveyor (2) with quick-release pin
(16).
f. Repeat steps d and e for right side of conveyor (2).
g. Raise upper rear door (9) to take slack out of two slings (6).
h. Remove two quick-release pins (7) from two conveyor support struts (8).
i. Loosen two friction clamps (14) on two conveyor support struts (8).
j. Raise upper rear door (9) until conveyor (2) is in required position.
k. Install two quick-release pins (7) from two conveyor support struts (8).
I. Tighten two friction clamps (14) on two conveyor support struts (8).
m. Lower upper rear door (9) and remove two slings (6) from both sides of conveyor (2)
and stow in hook (15).
2-154