TM 9-2350-277-34REPAIR DRIVER’S HATCH COVER HULL HINGES — Continued 0061 00INSTALLATION1. Clamp or tack weld new hinge (1) or (2) on mounting ring (3). Set cover on mounting ring. Check alignment of coverhinges with hinges of ring (3).2. Insert spring shield (4) through hinges (1)(2) and cover hinges (5)(6)(7). Seat shield in cover hinge (7).3. Make sure hinges (1) or (2) are aligned and spaced as shown.4. Weld hinge (1) or (2) to mounting ring (3) and hull. See TM 9-237. Use electrode type 5356.5. Clean the weld area and apply touch-up paint to repaired area. See TM 43-0139.FOLLOW-THROUGH STEPS1. Install driver’s hatch cover (see your -20).END OF TASK0061 00-3/4 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
