• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
FABRICATED TOOLSContinued - TM-9-2350-277-20-6_574
EXPENDABLE/DURABLE SUPPLIES AND MATERIALS LIST - TM-9-2350-277-20-6_577

TM-9-2350-277-20-6 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
  462    463    464    465    466  467  468    469    470    471    472  
TM 9-2350-277-20-6 FABRICATED TOOLS—Continued 0927 00 NOTES: 1.  Install minimum length (1 to 1-1/2 inches each) jumper wires (7) between pins (3), and insert pins into connector (1) as follows: 2-3 6-21 11-24 15-16 19-23 20-22 2.  Leave pins out of positions 1, 4, 5, 7, 8, 9, 10, 12, 13, 14, 17, 18, and 25. CAUTION The inverter under test may be damaged if plug connections are not exactly as specified or if wires are shorted to the shell/other wires.  Make sure wires are not pinched by the connector shell. 3.  Position two captive screws (6) in the ears of shell (2).  Install shell over connector (1) and secure with two screws (5) and nuts (4). 4.  Fill opening at the rear of shell (2) with sealant (8). 5.  Purpose of plug is to fault isolate the inverters to determine which one has failed. Inverter Test Solo Plug (M1068A3 Only) 0927 00-3/4 blank







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.