REPLACE DC POWER EXTENSION CABLE (W10) (M1068A3 ONLY) Continued
Install cable W10 in carrier.
Connect cable W10 plug P1 (1) to DC power extension box A9 jack J1 (2).
Route cable through three loop clamps (3) and attach to hull wall with three screws.
Attach six new straps (4) to secure slack in cable W10.
Attach loop clamp (5) to cable W10 and secure to hull wall with screw.
Connect cable W10 plug P14 (6) to power control box A1 jack J34 (7).
Connect battery ground lead (WP 0338 00).
Turn MASTER SWITCH ON (see your -10). Check that electrical system works properly.
Turn MASTER SWITCH OFF (see your -10).
END OF TASK
0844 00-3/4 blank