TM 9-2350-277-20-5
REPLACE FRONT BILGE PUMP AND STRAINER Continued
0632 00
INSTALLATION
1.
Remove screw (3) and washer from new pump (6). Discard washer.
2.
Install ground lead (5) on pump (6). Secure with two new lockwashers (4) and screw (3).
3.
Install elbow (2) and adapter (1) on pump (6). Use pipe wrench and adjustable wrench.
4.
Cement new cushion (7) on bottom of pump (6) with adhesive.
5.
Install pump (6) in carrier.
NOTE
Do not tighten strap screws until all four are installed.
6.
Install strap (8) and ground lead (9) on hull weldnuts. Secure with three new lockwashers (10), screw (11), new key
washer (12) and screw (13). Bend tabs on key washer.
7.
Install strap (14) on hull weldnuts. Secure with two screws (13) and new key washers (12). Bend tabs on key washers.
8.
Slide hose (15) on adapter (16). Secure with clamp (17).
0632 00-3