TM 9-2350-277-20-4
REPLACE FLOOR PLATES (M1068A3 ONLY) Continued
0544 00
3.
If necessary, remove two pads (6)(7), rubber strips (8), six seals (9), and seal (10) from crossmembers by scraping.
INSTALLATION
1.
If pads, strips, or seals (6) through (10) were removed, apply thin coat of adhesive to roughened side of surface. Allow to
dry 20-40 minutes. Apply thin coat of adhesive to metal surface of hull crossmembers. Allow to dry 30-120 seconds.
Install pads, strips, and seals on crossmembers and press surfaces together firmly.
2.
Place rear floor plate (5) and 2 front floor plates (4)(3) on hull crossmembers. Secure to hull with 13 lined washers (2)
and screws (1).
FOLLOW-THROUGH STEPS
1.
Install personnel heater floor duct (WP 0706 00).
2.
Install power supply storage box (WP 0824 00).
3.
Raise and lock ramp (see your -10).
4.
Stop engine (see your -10).
END OF TASK
0544 00-2