TM 9-2350-277-20-3
REPLACE REAR MAIN WIRING HARNESS (M113A3, M901A3, M981A3, M1059A3, AND
M58 ) Continued
0362 00
NOTE
The M58 does not use connector, bushing, and hardware only adhesive sealant on wiring
harness in hull opening.
44. Route circuit 23 (25), 24 (26), and 31 (27) leads through connector (28) out of hull. Install connector on top of hull (from
inside hull). (All except M58.)
NOTE
The M58 does not use connector on wiring harness in hull opening. On M58, route leads
through opening in hull. Apply adhesive sealant around harness, filling opening to a depth of
0.5 to 1.5 inches (1.27 to 3.81 cm).
45. Install rubber bushing (29) with leads (25), (26), (27) into connector (28). Secure rubber bushing in connector with
nut (30) and washer (31). (All except M58.)
0362 00-32