TM 9-2350-277-20-3
REPLACE PANEL LIGHTS AND INDICATOR LIGHTS Continued
0286 00
INSTALLATION
1.
If removed, install light assembly (1).
a.
Place light assembly (1) on rear of instrument panel. Secure with two new lockwashers (2) and screws (3).
CAUTION
Make sure circuit leads are connected to correct lights. See wiring diagrams at the end of this
manual.
b.
Connect circuit lead (4) to light assembly (1).
2.
Install light bulb (5).
a.
Install gasket (6) and light bulb (5) in light assembly (1). Push and turn light bulb to the right to secure.
b.
Install gasket (7) and lens (8) in light assembly (1). Turn lens to the right to secure.
FOLLOW-THROUGH STEPS
1.
Connect battery ground strap (WP 0337 00), (WP 0338 00), or (WP 0339 00).
2.
Turn MASTER SWITCH to ON (see your -10).
3.
Turn PANEL lights switch to ON, or BILGE PUMPS switch to ON, as needed, to check for proper installation of light
assembly (see your -10).
4.
Turn MASTER SWITCH OFF (see your -10).
END OF TASK
0286 00-3/4 blank